PowerBox Competition SRS inkl. SensorSwitch og patchledninger. BESTILLINGSVARE.

PowerBox Competition SRS inkl. SensorSwitch og patchledninger. BESTILLINGSVARE.

2.620,00 DKK

Model/Varenr.: PB4420
Lagerstatus: Ikke på lager

Du kan ikke gå til bestilling, da der er et produkt i din indkøbskurv som ikke er på lager. Gå til indkøbskurv


SRS - Serial Receiver System provides the ability to use receivers with a serial interface, such as those made by Spektrum DSM2 and DSMX, Multiplex M-LINK, Futaba S-BUS, Jeti R_SAT, HoTT, Weatronic.
Unrestricted channel assignment of the PowerBox outputs
Integral high-resolution graphic OLED screen with 128 x 64 pixels
Particularly user-friendly menu-based programming using the SensorSwitch
Signal amplification and interference suppression for 14 channels and 18 servos
Synchronised servo output for totally synchronous servo response
Flight recorder: records Lost Frames and Fail-Safe periods for all receivers connected to the backer
Variable frame rate, range 9 ms - 21 ms
16-bit processor for fast, high-resolution signal processing
Four match-channels, each for two servos. Accurate adjustment of all eight servos
Double regulated output voltage for receivers and servos
Can be connected to Spektrum and Multiplex MSB, Hott Weatronic downlink channel bus systems
Direct transmission of battery voltages and capacities to the transmitter
Separate voltage and capacity displays for each battery
Software-selectable servo voltage: 5.9 V or 7.4 V
Minimum value memory displays any voltage collapses
Large-area heat-sinks for high regulator power
Regulator monitor, regulator malfunction indicator
Support for three battery types: LiPo, NiMH / NiCd, LiFePo
Suppresses any servo feedback currents which might develop
Updateable with PowerBox Systems USB Interface connectors


Operating voltage: 4,0 Volts to 9,0 Volts
Power source:
2 x two-cell LiPO batteries 7,4 Volts
2 x five-cell NiCd or. NiMH batteries
2 x two-cell LiFePo batteries (A123)
Current drain:
switched on - approx. 125 mA
switched off - approx. 33 µA
Dropout voltage: approx. 0.25 V
Max. receiver and servo current:
2 x 10 A (stabilised) according to cooling , Peak 2 x 20 A
Servo signal resolution: 0.5 µs
Servo signal resolution: 0,5µs

Signal repeat rate:
9 ms, 12 ms, 15 ms, 18 ms, 21 ms (frame rate)
Screen: OLED 128 x 64 pixels, graphic
Servo sockets: 18Sockets, 14 channel
Temperature range: - 30 °C to + 75 °C
Weight: 115 g
SensorSwitch: 15 g
EMV approval: EN 55014-1:2006
CE approval: 2004/108/EG
WEEE Reg. No.: DE 639 766 11
This battery backer fulfils the EMV protective requirements, EN 55014-1:2006 with certificate dated 10 February 2011. EMC approval 2004/108/EG.